Adafruit Industries, Unique & fun DIY electronics and kits Wire Light LED Strand - 10 Cool White LEDs + Coin Cell Holder : ID 894 - Add sparkle to your project with these lovely silver wire LED strands. These strands are very interesting, they use two silver wires that are coated so they don't short if they touch, then tiny 1000mcd LEDs are bonded onto the wires and coated with epoxy. The result is a very
Add sparkle to your project with these lovely silver wire LED strands. These strands are very interesting, they use two silver wires that are coated so they don't short if they touch, then tiny 1000mcd LEDs are bonded onto the wires and coated with epoxy. The result is a very flexible silver wire with sparkly "fairy" lights that are much less visible than normal LEDs. They're still just LEDs, but in a fun new form-factor! They're even waterproof - you can dunk these or have them outdoors, just be sure to protect the battery holder.Each strand comes with 10 LEDs, approximately 10cm/4 inches apart for a 2 foot long strand of wire. At one end of the magnet wire, a double stranded-core wire is soldered on and heat-shrinked to protect it. A 2 x CR2032 coin cell holder with on/off switch is on the other side. Of course, if you want you can just cut the coin cell holder off and solder on a 3xAAA battery holder or 3xAA battery holder. To solder to the magnet wire, scrape off the coating first.Comes with 2 x CR2032 batteries and runs for about 8 hours continuously. Need more? We carry CR2032 batteries over here.Please note: There are no series resistor installed in the strand, if you want to use another supply you will need to calculate and solder in a resistor. The reason that two 3V coin cells can be used to drive LEDs with a forward voltage of about 3.2V is that coin cells have an internal resistance that makes up for the lack of a choke resistor. If you want to drive these via a 6V power supply, you'll want to put in a 20-220 ohm (or larger) resistor in series to avoid burning out the LEDs. If you want to use a 4.5V power supply, use 10-100 ohms (or larger).
Cr2032 Battery Holder Switch Light Battery Switch String
LED Fairy Lights - 10 Meter Connectable
Stellar Lighting Warm White 50 LED Bulbs String Light - 20m + 4
Flickering Miniature LED Lights – Evan Designs
Adafruit DotStar LED Strip - Addressable Cool White - 30 LED/m
Globe Smart LED Light Strip, 16.4-ft
Wire Light LED Strand - 10 Blue LEDs + Coin Cell Holder : ID 895
The 2 Best Smart Strip Lights of 2024
The 2 Best Smart Strip Lights of 2024
Dmeixs Battery Powered Led Strip Lights White Strip
Viewpick 10ft(3m) 30 LEDs Multicolored Fairy Lights
Wire Light LED Strand - 10 Warm White LEDs + Coin Cell Holder : ID
Cr2032 Battery Holder Switch Light Battery Switch String
Wire Light LED Strand - 10 Green LEDs + Coin Cell Holder : ID 896
