Basic Information: Printer Model: Kingroon KP3S MCU / Printerboard: Kingroon KP3 V1.2 klippy.log klippy.log (20.1 KB) Describe your issue: Hi folks, although it says “Never change a running system” or something similar I changed the print head of this little fellow and swapped the RasPi 3 with an OrangePi Zero that was used on my CoreXY before. Before all this I think I found a good config in terms of input shaping. Due to changed mass of the print head I rerun resonance measurement
More ringing with SuperSlicer vs Simplify3D 4.0 on Anycubic
Interpreting Input Shaping results from 2 different printer mount
Klipper: Input Shaping – Simply Explained
Creality Sonic Pad Based on Klipper Firmware, 7 Touch Screen 3D Printer Smart Pad with Higher
The LDO input shaper toolkit provides all the necessary parts for performing Klipper input shaper calibration with minimal hassle. For detailed
LDO Input Shaper Toolkit (ADXL345) for Klipper
How To Install Klipper On Sidewinder X2: Config And Setup
Resonance Compensation - Klipper documentation
Sovol SV07 Plus 3D Printer with Klipper Firmware, Max Print Speed
Desperation. Klipper updates mayhem. - General Discussion - Team FDM
